Enable/disable the checkbox in the settings for doors/keys in the iDrive system to enable/disable the acoustical lock confirmation. If the checkbox in the iDrive system does not allow selection, please check if “Acoustical lock/unlock confirmation” in the “Roof Function Center” control unit is set to “Active“ also. To make this work, the car has to be equipped with an alarm system.
Enable/disable the Active Sound Design. Please note that it is not possible to enable the Active Sound Design for cars that are not equipped with this option by factory.
Turn on the AC when activating the air recirculation mode.
Enable/disable storing of the air circulation setting. If this function is active, the last used air circulation setting will be restored during the next start of the car.
Apply the AUTO settings when switching from the AUTO mode to the manual mode.
Enable/disable the Automatic Air Recirculation function.
Enable/disable the acoustic signal that sounds when the reverse gear is engaged.
The maximum volume that is saved when the iDrive system is shut off and restored automatically on the next start-up.
Save the last used Auto Start Stop function setting for the next start of the car.
The brake deceleration at which the Brake Force Display is activated.
The speed at which the Brake Force Display is activated.
Enable/disable the checkbox in the lighting settings in the iDrive system to turn the daytime running light on or off.
The animation that is displayed when the iDrive system is started. Please note that the animation is not visible every time you start the car, but only under certain circumstances.
The displayed values of the tire pressure control in the iDrive system. Please note that the car has to be equipped with the required sensors to make this work.
Enable/disable the volume popup that is displayed when the volume is changed.
Enable/disable the Diesel logo.
Enable/disable the horn signal that sounds when locking the car with the engine running.
The car is locked automatically again if it has been unlocked and no door has been opened within the set time.
Enable/disable the window lifter interruption when a door is opened.
The remaining range at which the permanent low fuel warning is displayed.
The remaining range at which the temporary low fuel warning is displayed.
The lighting switch position where the automatic light control is active. To prevent the low beam to come on when the switch is set to “0”, use the option “Active in position A”.
Enable/disable the automatic switch-off of the fog lights when the high beam is turned on.
Allows the fog lights to be turned on with parking lights.
The hazard warning signal is activated automatically after an emergency braking.
The sensitivity of the rain-light-sensor that affects the automatic wiper and light activation.
Enable/disable the automatic mirror tilt for the right mirror, when the reverse gear is engaged. For this function to work, the car has to be equipped with power folding mirrors. Make sure the button in the door for selecting the mirror is set to the driver side also.
The tilt value of the right mirror, when the reverse gear is engaged.
Enable/disable the “5 times” one-touch turn signal option in the exterior lighting settings in the iDrive system.
The driven distance after the PDC is turned off automatically.
The speed at which the PDC and the Top View is turned off automatically.
The driven distance after the rear view camera is turned off automatically.
The speed at which the rear view camera is turned off automatically.
The memory duration of the seat heating/cooling settings.
Activate/deactivate the acoustic and visual seat belt reminder for the driver seat.
Activate/deactivate the acoustic and visual seat belt reminder for the passenger seat.
The delay when opening the boot lid with the remote control. This value can be increased to prevent accidental openings of the boot lid.
Enable video in motion. Please note the instructions displayed after coding.
Enable video playback from USB storage media. Use a backup to revert this coding once it has been applied.
Disable the warning that is displayed when using one of the cameras. Use a backup to revert this coding once it has been applied.
Disable the warning that is displayed when using the night vision camera. Use a backup to revert this coding once it has been applied.
Disable the warning that is displayed when the iDrive system is started. Use a backup to revert this coding once it has been applied.
Enable/disable the activation of the Welcome light in darkness only.